HP Remote Insight Lights-Out Edition II Board - Manual (Page 111)

Scripting, command line, and utility options 111
Command line argument Description
/RESET_RILOE Resets the RILOE II management processor to default factory
settings.
/DETECT Detects the RILOE II management processor on the target
server.
/RESET_RILOE Resets the RILOE II management processor.
/VIRT_FLOPPY Ignores the virtual floppy inserted error.
/MIN_FW-xxx Enables you to set the minimum firmware version on which the
RILOE II management processor runs.
/GET_STATUS Returns the status of the RILOE II management processor.
/GET_HOSTINFO Retrieves and displays the current host server information on
the RILOE II management processor and displays the server
name and number.
/GET_USERINFO Obtains the current users stored in the RILOE II management
processor board and displays the names, login names, and
security mask information.
/GET_NICCONFIG Retrieves and displays the NIC settings stored in the RILOE II
management processor.
/GET_DHCPCONFIG Retrieves and displays the DHCP settings stored in the RILOE II
management processor.
/GET_DIRCONFIG Retrieves and displays the DIRECTORY settings in the RILOE II
management processor.
/WRITE_XML=path\file
name.ext Reads the settings on the RILOE II management processor and
writes the NIC, DHCP, DIRECTORY, and user settings into an
XML hardware configuration script file.
/LOAD_XML=path\file name.ext Loads the script file and applies its changes to the current
configuration on the RILOE II management processor.
/VERIFY_XML Verifies the accuracy of the script file and generates an error
message for any incorrect data.
RIBCL XML Commands for CPQLODOS
CPQLODOS uses the same RIBCL XML commands as CPQLOCFG for the ,
and the XML scripting language blocks. Only those parameters unique to
CPQLODOS are discussed. For more information on , and
refer to:
• MOD_NETWORK_SETTINGS
• MOD_DIR_CONFIG
The following XML blocks are unique to CPQLODOS:
• CPQLODOS (on page 111 )
• ADD_USER (on page 112 )
CPQLODOS
This command is used to start and end a CPQLODOS session. It can be used only once in a script, and it
must be the first and last statement in an XML script.
Example: