HP 3Gb SAS Switch for HP BladeSystem c-Class - Manual (Page 72)

NOTE: Entering a range of port numbers is not supported. Each port must be entered
individually, separated by a comma.
3. [Optional] Verify that the zone group was created as intended.
For example, use one of the following commands:
=> sw local bsp all show detail
=> sw local zg OpenZone show
The display of this example is abbreviated, retaining key details. The display shows information
for the switch installed in interconnect bay 7, and that ports 1 and 2 are included in zone
group named OpenZone.
=> sw local bsp all show detail
Blade Enclosure at BottomC7000
Switch: Local
Blade Switch Port: 71
Port Number: 1
Zoning Status: OK
Presence: Present
Attached Device Type: SAS
Product ID: MSA2012sa
LED Status: Green
Zone Groups: OpenZone
Blade Switch Port: 72
Port Number: 2
Zoning Status: OK
Presence: Present
Attached Device Type: SAS
Product ID: MSA2012sa
LED Status: Green
Zone Groups: OpenZone
Blade Switch Port: 73
Port Number: 3
Zoning Status: OK
Presence: Absent
LED Status: Off
Blade Switch Port: 74
Port Number: 4
Zoning Status: OK
Presence: Absent
LED Status: Off
.
.
.
Blade Switch Port: 77
Port Number: 7
Zoning Status: OK
Presence: Absent
LED Status: Off
Blade Switch Port: 78
Port Number: 8
Zoning Status: OK
Presence: Absent
LED Status: Off
72 Performing common tasks