HP StorageWorks XP Remote Web Console Software User Manual
Page 31
2.
Issue the paircreate command on the SMPL volume to create a Snapshot XP pair. When creating
the first pair for the P-VOL, the pair status changes to COPY. When the operation completes, the
pair status changes to PAIR.
If you specify a volume that is already paired with one or more S-VOLs as the P-VOL to create
another pair, the pair status does not change to COPY. When the operation completes, the pair
status changes to PAIR.
NOTE:
• If you execute the paircreate command immediately after deleting the P-VOL's last
snapshot data, it might take time to create a new pair.
• If the pool capacity exceeds the threshold when a Snapshot XP pair is in PAIR status,
the pair status changes to PFUL in RAID Manager XP. For more information, see the
HP StorageWorks RAID Manager XP user guide
.
• If you issue the paircreate command when the pool capacity exceeds the threshold,
the command is rejected and you cannot create the pair.
3.
Issue the pairsplit command on the Snapshot XP pair in PAIR status to store the snapshot data in the
pool. When the operation completes, the pair status changes to PSUS.
NOTE:
If the pool capacity exceeds the threshold when a Snapshot XP pair is in PSUS status,
the pair status changes to PFUS in RAID Manager XP. For more information, see the
HP StorageWorks RAID Manager XP user guide
.
4.
To delete only snapshot data and leave the Snapshot XP pair, issue the pairresync command for the
PSUS or PFUS pair. During the operation, the pair status changes to COPY(RS).
To delete the Snapshot XP pair, issue the pairsplit-S command or use Command View XP or XP
Remote Web Console. During the operation, the pair status changes to SMPL(PD).
5.
To restore the pair, issue the pairresync-restore command on the Snapshot XP pair in PSUS status.
After that, the snapshot data is written back to the P-VOL. During the operation, the pair status
changes to COPY(RS-R). When the operation completes, the pair status changes to PAIR.
6.
A pool can contain only a predefined amount of data. If the total capacity of the snapshot data in
the pool exceeds the pool capacity, the pair status changes to PSUE. The pair status also changes to
PSUE when a failure occurs while restoring the pair or when the pool usage rate reaches 100 percent.
The pair status might change to PSUE when a failure occurs during a process other than restoring.
Whether the host can read and write the Snapshot XP pair's P-VOL or S-VOL depends on the pair status.
shows the relationship between the pair status and availability of host access.
HP StorageWorks Snapshot XP user guide
31