HP NetRAID 1 Controller - Manual (Page 33)

29
NetWare, OS/2, SCO and Vines: HP NetRAID
Config
Overview
HP NetRAID Config is a character-based, non-GUI utility that configures and monitors RAID
systems. HP NetRAID Config runs under the following operating systems:
•
Novell NetWare 3.x, 4.xx, 4.xx SMP, SFTIII 4.1
•
Banyan VINES 6.0 and 7.0
•
IBM OS/2 Server 2.11, 2.11 SMP, and Warp SMP
•
MS-DOS 3.2 or later
•
SCO ODT 3.0, MPX 3.0, and OpenServer 5.0
NOTE These instructions in using HP NetRAID Config refer specifically to the Novell
NetWare network operating system. Specific features may not be available in all
network operating systems, and the exact location of specific menu options may
vary.
This section describes the following functions:
A. HP NetRAID Config NOS Starting Commands
B. HP NetRAID Config Management Menu Options
C. Configuring Arrays and Logical Drives
D. Initializing Logical Drives
E. Formatting Physical Drives
F. Exiting HP NetRAID Config
A. HP NetRAID Config NOS Starting Commands
To start HP NetRAID Config, make sure the program file is in your file path and type the command
corresponding to your network operating system, as listed in the following table.
Operating
System
HP NetRAID Config
Starting Commands
NetWare load megamgr
OS/2 megaconf
SCO UNIX megamgr
VINES 6.0, 7.0 megaconf