HP NetRAID 1 Controller - Manual (Page 24)

20
7. Type "mon" from the HP NetRAID directory to run the monitor utility. Type "megaconf.exe"
from the HP NetRAID directory to run the configuration utility.
Microsoft Windows NT 4.0
1. Select "Start" from the taskbar.
2. Select "Run" from the "Start" menu.
3. Type ":\setup" at the "Open:" prompt ( is the drive letter of the floppy disk drive).
4. Follow the onscreen instructions.
Microsoft Windows 3.5x
1. Select "File/Run" from the Program Manager.
2. Type ":\setup" at the "Run" prompt and click "OK" ( is the drive letter of the floppy
disk drive).
3. Follow the onscreen instructions.
Novell NetWare 3.x, 4.xx, 4.xx SMP, SFT III 4.1
1. Exit to the DOS prompt.
2. Insert the floppy diskette containing the HP NetRAID Config utility.
3. Type “Copy :\*.nlm :\nwserver” and press the “Enter” key, where is the
drive letter for the floppy drive and is the hard disk where NetWare is installed.
4. To load the HP NetRAID Config utility, type “load :\nwserver\megamgr.nlm” and press
“Enter” at the NetWare command prompt.
SCO ODT 3.0, MPX 3.0, and Open Server 5.0
1. Please refer to the HP NetRAID SCO driver installation instructions in the SCO NOS
Installation Guide to install the adapter drivers and utilities. The utilities install automatically
with the driver.
2. After the driver installation is complete, the amirdmon utility is automatically run when the
system enters multi-user mode.
3. After the driver installation is complete, you may run the megamgr to configure the adapter
resources on a limited scale.