HP NetRAID 1 Controller - Manual (Page 23)

19
Refer to the following table for filenames of drivers and utilities specific to your NOS.
Network Operating
System Drivers Monitor Utilities
Configuration
Utilities
Banyan VINES 6.x, 7.0 Driver.o megamon megaconf
IBM OS/2 mraid.add monitor.cmd megaconf.exe
Windows NT mraidnt.sys * nraid.exe
NetWare 3.1x Mega3_1x.dsk
NetWare 4.1x
NetWare ASPI
Mega4_xx.ham
Mega4_xx.ddi
Mega4xx.dsk
Mega4xx.ddi
Megaspi.dsk
Megaspi.ddi
Megamon.nlm Megamgr.nlm
SCO Unix, OpenServe amird amirdmon megamgr
Network Operating Systems and Respective Driver and Utilities Files
*NOTE For Windows NT, the monitor function is embedded in the HP NetRAID
Assistant utility.
Installing Adapter Utilities
After the HP NetRAID or HP NetRAID-1 adapter and your Network Operating System have been
installed, use the following instructions to install adapter utilities software for your specific Network
Operating System.
Banyan VINES 6.0, 7.0
1. To install the adapter drivers and utilities, please refer to the HP NetRAID Banyan driver
installation instructions in the Banyan VINES NOS installation guide. The utilities are
installed automatically with the driver.
2. After completing the driver installation, you may run the megamon utility from the
background to monitor the status of adapter activities.
3. After completing the driver installation, you may run the megaconf utility from the
foreground to configure the adapter resources on a limited scale.
IBM OS/2 2.11, 2.11 SMP, and Warp SMP
1. Open a command prompt window.
2. Type the drive path where you want to install the drivers.
3. Type "cd\" and press Enter.
4. Type "md HP NetRAID" and press Enter.
5. Type "cd HP NetRAID" and press Enter.
6. Type "copy :\*.*" and press Enter ( is the drive letter of the floppy disk drive).