HP Designjet 3D Printer series - Manual (Page 29)

25
Oper
at
ion
The display panel during build
The top two lines of the display panel will show the printer status. See Figure 18. The bottom line
of the display panel will show the amount of model and support material that remains in the
carriers.
Figure 18 Display panel during build
Chamber Lights
When a part starts to build, the chamber lights are automatically ON. The default time-out for
the lights is 30 minutes. You can toggle the lights ON or OFF through the display panel.
You can set the chamber lights on permanently, however the chamber lights will return to factory
settings when power is cycled.
1. From Idle or Ready to Build, on the display panel press Maintenance.
a. Press Setup.
b. Press Lights Always On.
Repeat this process to turn this option off.
Pausing a build
While building a part, you may want to pause the build to allow for material replacement. To
pause the build at any time, from the display panel press Pause.
Resuming after pause
If you have pressed Pause, and are ready to resume building the part, press Resume and the
printer will resume printing.
NOTE: If a material amount is flashing, it indicates that the remaining material
will not be enough to complete the current build.
NOTE: The printer will complete the current tool path before pausing.
Printer status
Model file name
Support material
remaining
Model material
remaining
Printer status
Model file name
Support material
remaining in bay 1
Support material
remaining in bay 2
Model material remaining
in bay1
Model material remaining
in bay2
Single material bay
Dual material bay