HP Designjet 3D Printer series - Manual (Page 20)

16
Setup
Figure 10 Positioning printer
16. Remove the black plugs from the model and support Y blocks by pushing in on the coupler
rings and pulling outward. See Figure 11.
Figure 11 Removing the Y block plugs
17. Connect the short red striped material tube (M1) from model (M) coupler of upper material
bay to left side of model Y block by inserting firmly into red couplers. Gently pull the tube
to ensure it is properly inserted.
18. Repeat with the short black striped (S1) material tube for support side. See Figure 12.
Figure 12 Connecting the short material tubes