HP LaserJet 4250 - Manual (Page 35)

Cartridge out
The printer has two options for this menu item.
● Select CONTINUE to allow the printer to continue printing. A REPLACE CARTRIDGE
warning message appears until the print cartridge is replaced. Printing in this mode can
continue only for a specific number of pages. After that, the printer stops printing until
you replace the empty print cartridge. This is the default setting.
● Select STOP if you want the printer to stop printing until the empty print cartridge is
replaced.
To set the cartridge-out response
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight CARTRIDGE OUT.
7. Press ( S
ELECT
button) to select CARTRIDGE OUT.
8. Press ( U
P
button) or ( D
OWN
button) to select the appropriate setting.
9. Press ( S
ELECT
button) to set the selection.
10. Press M
ENU
to exit the menu.
Jam recovery
Use this option to configure the printer response to jams, including how the printer handles
the pages involved. AUTO is the default value.
● AUTO. The printer automatically turns jam recovery on when sufficient memory is
available.
● ON. The printer reprints any page that is involved in a jam. Additional memory is
allocated to store the last few pages that were printed, and this might cause overall
printer performance to suffer.
● OFF. The printer does not reprint any page that was involved in a jam. Because no
memory is used to store the most recent pages, overall printer performance might be
optimized.
ENWW Control panel 23