HP LaserJet 4250 - Manual (Page 29)

To show the IP address
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight SHOW ADDRESS.
7. Press ( S
ELECT
button) to select SHOW ADDRESS.
8. Press ( U
P
button) or ( D
OWN
button) to select the desired option.
9. Press ( S
ELECT
button) to select the option.
10. Press M
ENU
to exit the menu.
Tray behavior options
Four user-defined options are available for tray behavior:
● USE REQUESTED TRAY. Selecting EXCLUSIVELY ensures that the printer does not
automatically select another tray when you indicate that a specific tray should be used.
Selecting FIRST allows the printer to pull from a second tray if the specified tray is
empty. EXCLUSIVELY is the default setting.
● MANUALLY FEED PROMPT. If you select ALWAYS (the default value), the system
always shows a prompt before pulling from the multipurpose tray. If you select UNLESS
LOADED, the system displays the prompt only if the multipurpose tray is empty.
● PS DEFER MEDIA. This setting affects how non-HP PostScript drivers behave with the
printer. You do not need to change this setting if you use the drivers that HP supplies. If
set to ENABLED, non-HP PostScript drivers use the same HP tray selection method as
the HP drivers. If set to DISABLED, some non-HP PostScript drivers use the PostScript
tray selection method instead of the HP method.
● SIZE/TYPE PROMPT. Use this item to control whether the tray configuration message
and its corresponding prompts are shown whenever a tray is opened and closed. These
prompts instruct you to change the type or size if the tray is configured for a different
type or size than is loaded in the tray.
ENWW Control panel 17