HP StorageWorks 2000fc G2 Modular Smart Array - Manual (Page 26)

26 Installing, upgrading, and removing Simple SAN Connection Manager
The following is returned:
qla2xxx_conf 303752 1
qla2xxx 982688 0
scsi_mod 445298 qla2xxx
c. To verify that the correct driver is loaded, issue the following command:
# cat /proc/scsi/qla2xxx/* | grep "Driver version"
The following is returned:
Firmware version: 3.03.25 IPX
Driver version: 8.02.02-fo
Removing Simple SAN Connection Manager
The Simple SAN Connection Manager uses the installation wizard to remove all components currently
installed. You must reboot your computer following program removal. Follow the procedure for removing
Simple SAN Connection Manager from Windows (page 26) or Linux (page 27).
Removing Simple SAN Connection Manager in Windows
Follow these steps to remove the Simple SAN Connection Manager software from a server running
Windows.
To remove Simple SAN Connection Manager in Windows:
1. Insert the installation CD into your computer’s CD-ROM drive.
The HP Installation Wizard starts automatically.
The initial installation window (
Figure 9 ) opens.
Figure 9 Installation wizard: initial window for program removal
2. Click Remove Programs.
A message box asks if you are sure you want to remove the program.
3. Click Yes to proceed with program removal, or No to cancel.