HP StorageWorks 2000fc G2 Modular Smart Array - Manual (Page 24)

24 Installing, upgrading, and removing Simple SAN Connection Manager
Figure 8 Installation upgrade wizard: finished with errors
8. Click the View Error Log link to open an error log that provides additional information. You may be
prompted to upgrade, add, or modify components for successful installation.
9. Remove the Simple SAN Connection Manager CD, and then click Reboot.
10. Restart your computer to complete the installation process.
11. When you restart your computer, the system may report finding new hardware. If so, respond to these
messages by clicking Cancel.
Repeat this procedure to upgrade the software on additional Windows servers.
Linux installation: upgrade
Follow these steps to upgrade a previous installation of the required software on servers running Linux.
To upgrade the components required by Simple SAN Connection Manager on Linux:
1. Insert the installation CD into the CD-ROM drive of the server.
The installation CD should mount automatically in one of the following locations:
/media/cdrom/
/mnt/cdrom/
/media/cdrecorder/
If the installation CD is not mounted automatically, issue the following commands to mount the CD:
# mkdir -p /mnt/cdrom
# mount /dev/cdrom /mnt/cdrom
IMPORTANT: Under specific distributions, such as Red Hat Enterprise Linux 5 (RHEL 5), the
installation CD is auto-mounted using the following CD label:
# /media/HpInstallx.x/