HP Designjet T920 ePrinter series - Manual (Page 44)

Menu item Sub-menu item Sub-menu item Values and Description
IPSEC Specify the IPsec or Firewall status on the print server.
Keep : IPsec/Firewall status remains the same as
currently configured.
Disable : IPsec/Firewall operation on the print server is
disabled.
Reset Security Specify whether the current security settings on the print
server will be saved or reset to factory defaults.
No (default): The current security settings are
maintained.
Yes : Security settings are reset to factory defaults.
Link Speed The link speed and communication mode of the print
server must match the network. The available settings
depend on the device and installed print server. Select
one of the following link configuration settings:
CAUTION: If you change the link setting, network
communications with the print server and network device
might be lost.
Auto (default): The print server uses auto-negotiation to
configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on the
detected link speed of the hub/switch port. (A 1000T
half-duplex selection is not supported.)
10T Half : 10 Mbps, half-duplex operation.
10T Full : 10 Mbps, Full-duplex operation.
100TX Half : 100 Mbps, half-duplex operation.
100TX Full : 100 Mbps, full-duplex operation.
100TX Auto : Limits auto-negotiation to a maximum link
speed of 100 Mbps.
1000TX Full : 1000 Mbps, full-duplex operation.
Embedded services
Key networking services embedded in the printer are listed below. For the latest features and services, visit
http://www.hp.com/go/jetdirect .
● Configuration and Management
◦ BootP/DHCP (IPv4 only)
◦ DHCPv6
◦ TFTP (IPv4 only)
◦ Web Proxy (Automatic/Manual cURL)
◦ LLMNR
◦ Telnet (IPv4 only)
◦ SNMP (v1, v2c, v3) agents
36 Chapter 4 Network configuration ENWW