HP ProLiant DL360 G7 Server - Manual (Page 64)

Hardware options installation 64
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect the
power cord to the power supply until the power supply is installed.
4. Install the redundant power supply into the bay until it clicks.
5. Connect the power cord to the power supply.
6. Use the strain relief clip from the server hardware kit to secure the power cord.
7. Route the power cord through the cable management solution.
8. Connect the power cord to the power source.
9. Be sure that the power supply LED is green (" Rear panel LEDs and buttons " on page 9 ).
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1. Installing the Trusted Platform Module board (on page 65 ).
2. Retaining the recovery key/password (on page 66 ).