HP ProLiant DL360 G7 Server - Manual (Page 46)

Hardware options installation 46
Hot-plug SAS and SATA hard drive options
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number (" SAS and SATA device
numbers " on page 15 ).
• Hard drives must be SFF types.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Removing hard drive blanks
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Remove the component as indicated.
Removing hard drive bezel blanks
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Remove hard drives 1 and 2 (" Removing a hot-plug SAS hard drive " on page 47 ).