HP ProLiant DL360 G7 Server - Manual (Page 59)

Hardware options installation 59
6. Install the expansion board into the slot until it seats firmly. The same procedures apply for installing an
expansion board in PCI expansion slot 1.
7. Install the PCI riser board assembly (on page 23 ).
IMPORTANT: The server does not power up if the PCI riser board assembly is not seated
properly.
8. Connect all internal or external cabling to the expansion boards.
9. Install the access panel (on page 20 ).
10. Slide the server into the rack.
11. Power up the server (on page 18 ).
Installing a PCI-X riser board
IMPORTANT: The PCI-X riser board installed in this document supports PCI-X expansion boards
only.
1. Power down the server (on page 18 ).
2. Extend the server from the rack (on page 18 ).
3. Remove the access panel (on page 20 ).
4. Remove the PCI riser board assembly (on page 22 ).
5. Remove all expansion boards, if installed.