HP ProLiant DL360 G7 Server - Manual (Page 61)

Hardware options installation 61
Before installing a high-power graphics adapter (150W) in the server, be sure that the power supplies
support the installation of the adapter. Due the high power requirements for the adapter, a 750W power
supply may be required. For more information, see the HP Enterprise Configurator website
( http://h30099.www3.hp.com/configurator/ ).
To install the component:
1. Power down the server (on page 18 ).
2. Extend the server from the rack (on page 18 ).
3. Remove the access panel (on page 20 ).
4. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 20 ).
5. Remove the air baffle (on page 21 ).
6. Remove the fan blank.
7. Install the fan module.
8. Remove the PCI riser board assembly (on page 22 ).
9. Remove expansion slot cover 2 from the PCI riser board assembly.