HP Laserjet p3015 - Manual (Page 81)

Manually configure IPv6 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv6 address.
1. Press the Menu button .
2. Open each of the following menus. Press the down arrow to highlight it and then press the OK
button to select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV6 SETTINGS
f. ADDRESS
g. MANUAL SETTINGS
h. ENABLE
i. ON
j. ADDRESS
3. Use the numeric keypad, or press the up arrow or the down arrow to enter the address. Press
the
OK button.
NOTE: If you are using the arrow buttons to enter the address, you must press the OK button
after entering each character.
4. Press the up arrow or the down arrow to select the stop character . Press the OK button.
5. Press the Menu button to return to the Ready state.
ENWW Network configuration 69