HP Laserjet p3015 - Manual (Page 148)

4. If the EIO card requires a cable connection, connect the cable.
5. Turn on the product, and then print a configuration page to verify that the new EIO card is
recognized. See
Print the information and show-me-how pages on page 108 .
NOTE: When you print a configuration page, an HP Jetdirect configuration page that contains network
configuration and status information also prints.
Remove an EIO card
1. Turn off the product.
2. Disconnect any cables from the EIO card.
3. Loosen the two screws from the EIO card, and then remove the EIO card from the EIO slot.
4. Place the cover plate from the EIO slot onto the back of the product. Insert and tighten the two
screws.
5. Turn on the product.
136 Chapter 9 Manage and maintain the product ENWW