HP Laserjet p3015 - Manual (Page 33)

Configure device menu
Use the CONFIGURE DEVICE menu for the following tasks:
● Change the default printing settings.
● Adjust the print quality.
● Change the system configuration and I/O options.
● Reset the default settings.
Printing menu
These settings affect only jobs without identified properties. Most jobs identify all of the properties and
override the values set from this menu.
To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the
PRINTING menu.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no
default.
Menu item Values Description
COPIES Range: 1 - 32000 Set the default number of copies for print
jobs. The default number is 1.
DEFAULT PAPER SIZE A list of available sizes appears. Set the default paper size.
DEFAULT CUSTOM PAPER SIZE ● UNIT OF MEASURE
● X DIMENSION
● Y DIMENSION
Set the default size for any custom print job.
DUPLEX OFF*
ON
Enable or disable two-sided printing.
NOTE: This menu is available only on the
d, dn, and x models.
DUPLEX BINDING LONG EDGE*
SHORT EDGE
Change the binding edge for two-sided
printing.
NOTE: This menu is available only on the
d, dn, and x models.
OVERRIDE A4/LETTER NO
YES*
Set the product to print an A4 job on letter-
size paper when no A4 paper is loaded.
MANUAL FEED OFF*
ON
Makes the MANUAL FEED setting the
default for jobs that do not select a tray.
EDGE TO EDGE OVERRIDE NO*
YES
Change the printable area of Letter and A4-
size paper to 2 mm from the left and right
edges for single-sided printing. The
standard printable area is 4 mm from the
left and right edges.
ENWW Configure device menu 21