HP Laserjet p3015 - Manual (Page 48)

Item Sub-item Sub-item Values Description
RTT AVERAGE Shows the average round-trip-time (RTT),
from 0 to 4096 milliseconds, for packet
transmission and response. The default is 0.
PING IN
PROGRESS YES
NO*
Select whether the control panel indicates
when a ping test is in progress.
REFRESH YES
NO*
When viewing the ping test results, this item
updates the ping test data with current
results. A refresh automatically occurs when
the menu times out or you manually return to
the main menu.
LINK SPEED AUTO*
10T HALF
10T FULL
100TX HALF
100TX FULL
100TX AUTO
1000TX FULL
The link speed and communication mode of
the print server must match the network. The
available settings depend on the product and
installed print server.
CAUTION: If you change the link setting,
network communications with the print server
and network product might be lost.
AUTO: The print server uses auto-
negotiation to configure itself with the highest
link speed and communication mode
allowed. If auto-negotiation fails, either
100TX HALF or 10T HALF is set depending
on the detected link speed of the hub/switch
port. (A 1000T half-duplex selection is not
supported.)
10T HALF: 10 Mbps, half-duplex operation.
10T FULL: 10 Mbps, full-duplex operation.
100TX HALF: 100 Mbps, half-duplex
operation.
100TX FULL: 100 Mbps, full-duplex
operation.
100TX AUTO: Limits auto-negotiation to a
maximum link speed of 100 Mbps.
1000TX FULL: 1000 Mbps, full-duplex
operation.
Resets menu
Use the RESETS menu to reset factory settings, disable and enable sleep mode, and update the product
after new supplies are installed.
To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the
RESETS menu.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no
default.
36 Chapter 2 Control panel ENWW