HP Compaq Integrated Smart Array Controller - Manual (Page 61)

Installing the Operating System Drivers 5-21
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq Integrated Smart Array Controller User Guide Comments:
Part Number: 153236-001 File Name: f-ch5 Installing the Operating System Drivers.doc Last Saved On: 8/26/99 8:12 PM
Installing the Driver
Install the driver file to the OS/2 directory on your boot drive:
1. Place the Compaq SSD for IBM OS/2 installation diskette labeled
System and Storage Drivers into the diskette drive.
2. From the OS/2 command prompt, type:
A: Ddinstal
3. Click Change to change the source directory to A:/ADD.
4. Select Compaq Array Driver for OS/2 from the list of drivers.
5. Click OK to continue.
The CPQARRAY.ADD driver file is copied to the x:\os2 directory
(where x is the boot drive) and the CONFIG.SYS file is updated to load
the driver first at startup. In other words, the drive on this controller is
the boot drive.
IMPORTANT: To boot from a drive attached to the integrated SCSI controller, or other
drive, change the CONFIG.SYS file before you reboot the server. Edit the CONFIG.SYS file
to reorder the BASEDEV=CPQARRAY.ADD statement so that it appears after the BASEDEV
statement corresponding to the boot driver.
6. Save the updated CONFIG.SYS file and exit the editor.
7. Perform a normal system shutdown and restart the server to load the
new driver.
8. Proceed to the last section in this chapter, “Updating the Compaq
Insight Management Agents.”