HP Compaq Integrated Smart Array Controller - Manual (Page 50)

5-10 Compaq Integrated Smart Array Controller User Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq Integrated Smart Array Controller User Guide Comments:
Part Number: 153236-001 File Name: f-ch5 Installing the Operating System Drivers.doc Last Saved On: 8/26/99 8:12 PM
To read the NTREADME.HLP file, you need a server running Microsoft
Windows NT or a workstation running Windows. Perform the following steps:
1. Insert the Compaq SSD for Windows NT diskettes, beginning with
diskette 1, into the diskette drive.
2. At a command prompt, make A: the current drive and type:
README.BAT
or
From the File pull-down menu in Windows Program Manager, select
Run and type:
A:\README.BAT
3. Select help topics to read or print. Important help topics include:
G Compaq SSD for Windows NT installation methods
G Using the Compaq SSD for Windows NT Setup program
G Windows NT device driver specifics
G Compaq SCSI controller support
G Compaq drive array support
G Installing the Compaq drive array driver during Windows NT
installation
G Installing the Compaq drive array driver after Windows NT
installation
G Updating the Compaq drive array driver
G Removing the Compaq drive array driver
General Installation Procedures
Sources for installing device drivers on a Windows NT server include:
■ Compaq SSD for Windows NT Setup program installation
■ Standard Windows NT device driver installation during initial
installation of the Windows NT operating system
If you are installing the driver after installing Windows NT, use the Compaq
SSD for Windows NT installation method. If you install the driver during the
initial Windows NT installation, you must use the standard Windows NT
device driver installation method. Both methods are outlined in this chapter.