HP Lights-Out 100 Remote Management - Manual (Page 19)

Using the PuTTY utility
PuTTY 0.54 is a terminal emulation product that includes support for telnet and the SSH protocol.
PuTTY 0.54 is available for download from the Internet.
•
To start a PuTTY session, double-click the PuTTY icon in the directory in which PuTTY is installed.
•
To start a PuTTY session from the command line:
To start a connection to a server called host, enter:
putty.exe [-ssh | -telnet | -rlogin | -raw] [user@]host
◦
◦
For telnet sessions, you can also enter the following alternative syntax:
putty.exe telnet://host[:port]/
◦
To start an existing saved session called session name, enter:
putty.exe -load "session name"
When you press Enter using PuTTY versions earlier than 0.54, two line feeds might appear on a
single line feed. To avoid this issue and for best results, HP recommends using version 0.54 or
later.
Using the OpenSSH utility
OpenSSH is a free version of the SSH protocol available for download on the Internet.
To start an OpenSSH client in Linux, at the command prompt enter:
ssh -l loginname ipaddress/dns name
Using CLP
HP has worked with key industry partners within Distributed Management Task Force, Inc. to define
an industry-standard set of commands. The SMASH suite will standardize manageability interfaces
for servers. The Lights-Out 100 remote management processor implements the command set defined
in the Server Management Command Line Protocol Specification, 1.00 Draft. The CLP replaces
the simple CLI that was released previously and is no longer supported.
The management processor functionality accessible from the SMASH CLP is a low-bandwidth
interface and provides similar functionality to the web interface. The CLP is designed for users who
prefer a nongraphical interface. The CLP is accessible through the following methods:
•
Telnet
•
SSH connection
•
Physical serial port
LO100 CLP supports four simultaneous SSH connections, two SSH connections and two Telnet
connection, or one SSH connection and three Telnet connections. You cannot have more than four
simultaneous SSH connections and up to three (Telnet and SSH) connections at a time.
CLP syntax
The general syntax of CLP command is:
•
Verbs— The following verbs are supported:
cd
◦
◦
help
Using CLP 19