HP NonStop G-Series - Manual (Page 35)

Measure Command Interface (MEASCOM)
Measure User’s Guide — 520560-003
2 -7
Starting and Stopping MEASCOM
To list the currently active measurements before stopping the Measure subsystem:
43> MEASCOM
MEASURE Performance Monitor - T9086G10 - (16DEC03) - \HATI
(C)1986 Tandem (C)2003 Hewlett Packard Development Company, L.P.
1+ STATUS MEASSUBSYS
Number of Active (or Configured) Measurements = 0
2+ STOP MEASSUBSYS
If you enter the STOP MEASSUBSYS command from an interactive MEASCOM
session and measurements are active, this prompt appears:
n measurement(s) still active; still stop the subsystem (y/n)?
A YES response aborts all active measurements before the subsystem is stopped. If
transient entities do not exist or the measurement was run without a collection interval,
the records are lost. Closing records are not written when a measurement is aborted. A
NO response cancels the STOP MEASSUBSYS command.
Starting and Stopping MEASCOM
Use the TACL RUN command to start the MEASCOM command interpreter process.
where:
RUN $disk.subvol
is required only if MEASCOM is not located in $SYSTEM.SYSTEM or
$SYSTEM.SYS
nn .
To stop a MEASCOM session:
10+ EXIT
4>
14> [ RUN $disk.subvol ] MEASCOM