HP Integrity rx2660 Servers - Manual (Page 68)

Scripted deployment 68
Command-line
argument
Description
HP Integrity Servers.
/use_d[ownloaded] This argument specifies that the checkbox for Include components previously
downloaded from HP.com on the Source Selection screen is selected. This
enables those previously downloaded components to be included in the list of
possible updates. This argument is not supported on HP Integrity Servers.
/tpmbypass or
/ignore_tpm
This argument specifies that if a TPM is enabled, then the warning message
can be ignored and component installation continues.
/use_snmp This argument specifies that components, which use SNMP protocol, are
available to be selected for installation. These components are available for
selection by default. When the /use_snmp argument is used, and the
/use_wmi argument is not, the WMI components are optional. This
argument does not apply to HP Integrity Servers.
/use_wmi This argument specifies that components, which use WMI protocol, are
available to be selected for installation. These components are optional by
default and are not installed unless this argument is used. When the
/use_wmi argument is used, and the /use_snmp argument is not, the
SNMP components are optional. This argument does not apply to HP Integrity
Servers.
/use_latest This argument is a filter switch for use with bundles. The argument enables
you to use the latest version of the bundle when multiple versions of bundles
are listed on the command line. If no bundles are specified on the command
line, and multiple bundles are in the directory, then the /use_latest
argument enables HP SUM to use the bundle with the latest version for
installation.
/romonly This argument is a filter switch and enables the user to view only the firmware
components required for installation. When using this filter switch, you must
exit, and then restart HP SUM to return to an unfiltered state. Do not use the
/romonly argument with the /softwareonly argument. (Applies to
firmware only.)
/softwareonly This argument is a filter switch and enables the user to view only the software
components required for installation. When using this filter switch, you must
exit, and then restart HP SUM to return to an unfiltered state.
Do not use the /softwareonly argument with the /romonly argument.
Overriding errors
/continue_on_error This argument causes the installation to continue and ignore errors. Valid
values are:
• =ServerNotFound
• =BadPassword
• =FailedDependencies
The ServerNotFound option can be used to bypass inactive or unavailable
remote hosts when deploying firmware or software to multiple remote hosts at
the same time.
/override_existing_
connection
This argument defines the behavior when a remote target has an existing HP
SUM session in progress. This argument overrides the session in progress and
reinitializes the installation framework on the remote host.