Boot bios, Introduction, System requirements – HP StorageWorks Modular Arrays User Manual
Page 71: Chapter
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: Compaq StorageWorks 64-Bit PCI-To-Fibre Channel Host Bus Adapter User Guide Comments:
Part Number: AA-RKPDA-TE 173941-001 File Name: H-CH7 BOOT BIOS.DOC Last Saved On: 12/8/99 11:04 AM
Chapter
7
Boot BIOS
Introduction
Boot BIOS is a set of x86 instructions in the 64-Bit PCI-To-Fibre Channel
Host Bus Adapter (HBA) flash ROM that lets you designate a fibre channel
hard drive as the boot drive. Boot BIOS works with the existing system BIOS
on Intel Pentium class PCI system boards.
NOTE: The examples in this chapter use the Windows NT 4.0 operating system.
Boot BIOS does the following:
■
Supports up to eight fibre channel HBAs per computer
■
Detects up to 99 devices per HBA
■
Displays a maximum of 16 devices during the boot process
System Requirements
■
Intel Pentium Class computer, with system BIOS copyright 1995 or later
■
MS-DOS 6.0 or higher
■
Windows NT 4.0 installation media
■
Installed HBA