HP System Management Homepage-Software - Manual (Page 32)

7 Remove
Remove all checked items
from the list.
4 Add
Adds the combined IP and
Netmask address to the list.
1 Enable Binding
When checked, indicates
that binding will be used.
2 Subnet Address
Valid address.
8 5 Check All
Check/uncheck all items in
the list of addresses.
Apply
Save all items in the address
list.
3 Netmask
Valid netmask.
6 Checkbox
Multiple addresses/names.
To configure IP Binding:
1.
Select Settings from the menu.
2. In the System Management Homepage box, click the Security link.
3. Click the IP Binding link.
4. Enter the Subnet IP Address.
5. Enter the Netmask.
6. Click Add to add the Subnet IP Address and Netmask that were entered in the preceding
steps.
You can add up to five subnet IP addresses and netmasks by repeating steps 4 through 7.
7. Click Apply to apply the configurations.
NOTE: The netmask is applicable only for IPv4 addresses.
To remove IP addresses from the list:
1.
Select Settings from the menu.
2. In the System Management Homepage box, click the Security link.
3. Click the IP Binding link.
4. Select the check box beside the IP address you want to remove.
5. Click Remove.
6. Click Apply to apply the configurations.
Each IP address and netmask must consist of four octets with values between 0 and 255 (the same
for each netmask).
Netmasks must start with the number 1 in the highest bit and continue with all number 1s until they
switch to all number 0s (for example, 255.255.0.0, 192.0.0.0, 255.192.0.0).
IP Restricted Login category
IP Restricted login enables HP SMH to restrict login access based on the IP address of a system
from which the sign-in is attempted.
32 The Settings page