HP XP Data Shredder Software User Manual
Page 149
Table 17 System parameter settings (TagmaStore AMS and TagmaStore WMS
subsystems)
Pane name
Parameters
Parameter setting
Start Attribute
•
Single Mode
Specify this parameter when the
TagmaStore AMS or TagmaStore
WMS subsystem is in the
one-controller configuration.
•
Dual Active Mode
Specify this parameter when the
TagmaStore AMS or TagmaStore
WMS subsystem is in the
two-controller configuration.
Delay Planned Shutdown
You can either specify this
parameter or omit specifying this
parameter.
Drive blocking mode
You can either specify this
parameter or omit specifying this
parameter.
Vendor ID
Keep this parameter as HITACHI
(default), and do not change.
Product ID
Keep this parameter as DF600F
(default), and do not change.
ROM Microprogram Version
You can either specify this
parameter or omit specifying this
parameter.
Boot Options
RAM Microprogram Version
You can either specify this
parameter or omit specifying this
parameter.
Option
You can either specify this
parameter or omit specifying this
parameter.
Operation if the processor failure
occurs
Set this parameter to Reset of
occurred.
WEB Title
You can either specify this
parameter or omit specifying this
parameter.
System Parameter
Write and verify mode
Set this parameter to ON.
Port Options
Port Option
You can either specify this
parameter or omit specifying this
parameter.
Host Connection Mode 1
Set this parameter to Standard
Mode.
Host Connection Mode
Host Connection Mode 2
Do not specify any parameters.
NOTE:
Do not specify HISUP OFF
mode, either.
NOTE:
You can either specify or omit any other parameters.
External Storage XP user guide
149