HP XP Data Shredder Software - Manual (Page 104)

Deleting alternate paths by selecting multiple external LUs
(Delete Paths)
You can delete paths for multiple volumes that belong to the same external LU group at one time. To
delete alternate paths for multiple external LUs at one time, select the alternate path in the Delete Paths
window, check the setting in the Path Setting window, and apply the setting to the array.
CAUTION:
At least one normal path must be set on each mapped external LU.
NOTE:
Use the Delete Paths window to delete paths to multiple external LUs at one time. However, the deleted
path settings might not be applied because of the current path setting of each volume. After you set the
deletion in the Delete Paths window, check whether or not the new path settings can be applied in the
Path Setting window for each external LU. If the setting cannot be applied, the setting from the Delete
Paths window does not appear on the Path Setting window. The setting from the Delete Paths window
also does not appear in the Preset list or in the LU Operation pane.
Figure 55 Delete Paths window
• Port
Local array ports. After selecting a port, you can add the paths. One of the following icons appears
for each port:
Icon Description
Port in Standard mode.
Port in Initiator/External MIX mode.
• Selected Paths
Paths of WWNs to be deleted. WWNs identify ports on the external array. Nothing is displayed
when you first access the Delete Paths window.
• Unselected Paths
Ports (WWNs) on the external array that have paths configured for connecting with the local array
port selected in the Port list. Select WWNs from this list to delete paths.
• Set
Moves WWNs selected in Unselected Paths to Selected Paths.
104 Configuring external LUs