Table 13 – HP XP Data Shredder Software User Manual
Page 144
Table 13 System parameter settings (Thunder 9500V subsystems)
Pane name
Parameter
Parameter setting
Start Attribute
•
Single Mode
Specify this parameter when the
Thunder 9500V subsystem is in the
one-controller configuration.
•
Dual Active Mode
Specify this parameter when the
Thunder 9500V subsystem is in the
two-controller configuration.
NOTE:
Be sure to specify that Data Share
Mode will be used.
System Startup Settings
•
Hot Stand-By Mode
Do not specify this parameter.
Common 1
Delay Planned Shutdown
You can either specify this parameter
or omit specifying this parameter.
OPTION 1
SCSI Fibre Channel Common Options
You can either specify this parameter
or omit specifying this parameter.
OPTION 2
SCSI Fibre Channel Common Options
You can either specify this parameter
or omit specifying this parameter.
Data Striping
Operation if the processor failure
occurs
Set this parameter to Reset of occurred.
Command Queuing Mode
Set this parameter to ON.
Vendor ID
Keep this parameter as HITACHI
(default), and do not change.
Product ID
Keep this parameter as DF600F
(default), and do not change.
ROM Microprogram Version
You can either specify this parameter
or omit specifying this parameter.
RAM Microprogram Version
You can either specify this parameter
or omit specifying this parameter.
Inquiry Setting
WEB Title
You can either specify this parameter
or omit specifying this parameter.
Reset/LIP Mode
•
Reset/LIP Mode (Signal)
You can either specify this parameter
or omit specifying this parameter.
•
Reset/LIP Mode (Process)
You can either specify this parameter
or omit specifying this parameter.
Port Type
•
LIP Reset Mode
You can either specify this parameter
or omit specifying this parameter.
RS232C Error Information Outflow
Mode
You can either specify this parameter
or omit specifying this parameter.
Controller Option
Write and verify mode
Set this parameter to ON.
Host Connection Mode 1
Set this parameter to Standard Mode.
Host Connection Mode
Host Connection Mode 2
Specify HISUP Mode.
NOTE:
Do not specify any other parameters.
144
Notes on connecting external arrays