Removing a system, Editing network and disk i/o capacity, Getting there – HP Matrix Operating Environment Software User Manual
Page 96: Setting the upper bound values, Getting there setting the upper bound values
Removing a system
As your scenarios evolve, you might need to remove systems from a scenario to represent planned
or actual changes.
1.
From the System tab of the scenario editor, click in the check boxes beside the systems that
you want to remove from the scenario.
2.
Select Edit
→Remove Systems... from the menu bar.
A confirmation screen listing the systems you are removing will be presented.
3.
Click the OK button.
You will be returned to the Capacity Advisor - Edit Scenario screen with the systems you
selected removed.
Editing network and disk I/O capacity
Use the Edit Network and Disk I/O Capacity page to set the upper bound value of network and
disk I/O capacity for the selected set of systems. Setting this upper bound creates the maximum
capacity value for such items as the network and disk I/O utilization graphs shown for the
systems, the graphs and values shown in a profile viewer, and the HP Smart Solver calculations.
Further, when using Capacity Advisor, the currently set upper bound values here are propagated
as the upper bound values for the systems when a scenario containing the systems are created.
Getting there
1.
From the Virtualization Manager
Visualization view
, select a compartment or
sub-compartment for a system for which you want to edit its network I/O and disk I/O
capacity.
2.
From the Virtualization Manager
Configure menu
, select Edit Network and Disk I/O
Capacity...
.
The Edit Network and Disk I/O Capacity screen displays.
TIP:
This feature can also be accessed from profile viewers opened from the Visualization
view.
Setting the upper bound values
1.
Select to use the maximum observed network and disk I/O readings
Or
Manually specify the network and disk I/O capacity values
a.
Enter a value for network I/O in Mb/s.
b.
Enter a value for disk I/O in MB/s.
NOTE:
If desired, you can set the manual maximum value to be greater than the
observed maximum.
The designated values are used to populate the Selected Systems table and are applied
elsewhere by Capacity Advisor.
2.
Select Apply or OK to apply and preserve your changes, respectively.
96
Procedures