HP Matrix Operating Environment Software - Manual (Page 102)

Calibrating a single system
There are multiple paths to edit the power settings for a single system:
•
On the Visualization tab, select the check box to the left of the desired physical system, and
select Configure
→Calibrate Power (All Selected Systems) on the Virtualization Manager
menu bar.
• From the profile viewer for a specific system, click the Calibrate Power link.
TIP: Click the power meter on a physical system shown on the Visualization tab to view
its power information and to access the power profile viewer for that system.
Procedure 5-89 Selecting a calibration option for a single system
1. Review the current configuration shown in the summary area.
2. Click the radio button to the left of the desired calibration option.
3. Supply values for idle and maximum power usage when manual calibration is selected. (See
“Power calibration calculations” (page 125) for assistance in determining valid values for
particular systems.)
Procedure 5-90 Calibrating HP Insight Control power management (IPM)
• Click the “Calibrate” link.
Results are posted in the Last Attempted Auto-Calibration table.
If an error is indicated, read the “Troubleshooting” and “Notes” column for help on fixing
the error.
Procedure 5-91 Clearing current power management calibration values
• Click the “Clear Calibration Data” link.
Calibration values are deleted. Results are posted in the Last Attempted Auto-Calibration
table.
If an error is indicated, read the “Troubleshooting” and “Notes” column for help on fixing
the error.
Procedure 5-92 Updating iLO2 data and calibration
• Click the “Collect iLO2 Data” link.
The latest power usage data for this system is obtained and used to update the calibration
for this system. Results are posted in the Last Attempted Auto-Calibration table.
If an error is indicated, read the “Troubleshooting” and “Notes” column for help on fixing
the error.
Procedure 5-93 Configuring power management
1. Examine the Power Management Plug-in Configuration table.
2. In order of presentation, configure or correct each step listed in the table, as needed.
a.
Look at the icon in the Status column. If the status icon shows
•
, then the step is working correctly.
• , then this step is not working correctly.
• , indicates waiting for a previous step to complete successfully.
b. Fix errors in the order that they appear in the table. Use the information in the Notes
column to determine what you need to do. Use the links in the Help column to resolve
the problem(s) for that step.
3. When all the icons show a green status, select Apply or OK to complete the power calibration
for the selected system .
102 Procedures