AT&T System 85 - Manual (Page 97)

CHAPTER 4. OPERATING FEATURES
To answer a recall:
1. When the ATND light flashes and you hear an audible ring, press [ANSWER] .
Audible ring stops. ATND light goes on. PA light goes off.
2 .
Press [CANCL] , and report to the caller.
3 . If the caller wishes to be connected to another extension number, press [START] . Dial
the extension number.
4.
Press [RELEASE] .
Display and ATND lights go off. PA light goes on.
5 .
If the caller does not wish to wait, press [RELEASE] .
Display and ATND lights go off. PA light goes on.
To answer a terminal-to-attendant call from a branch location:
1. When the ATND light flashes and you hear audible ring, press [ANSWER] .
Audible ring stops. ATND light goes on. PA light goes off. Display shows branch
location. Two bursts of tone identify the call as a terminal-to-attendant call.
System Status Indicators at the Main Location
At the main location, System Status Indicators (SSIs) (Figure 4-1)
of up to 110 Release Link Trunks (RLTs). The table in Figure 4-1
and the system status associated with each light.
To test SSI light
1. Press
ATND
2. Press
Listen
an idle loop button.
light goes on. PA light goes off.
[START] .
for dial tone.
3. Dial Light Test code.
Listen for confirmation
operation.
show the busy/idle status
shows the light conditions
tone. All lights on the SSI should go on to indicate proper
4-75