AT&T System 85 - Manual (Page 70)

CHAPTER 4. OPERATING FEATURES
4.
5.
6.
7.
To be reconnected to the conference, press [SPLIT] .
SPLIT light goes on.
To release from the conference, press [RELEASE]. However, before releasing, make
sure one conferee is an extension number user and is local to the attendant.
Otherwise outside parties will be disconnected.
If you are recalled by the conference, the ATND light flashes. You hear an audible
ring. Press the loop button below the flashing ATND light.
ATND light goes on. Audible ring stops. Display shows
CONF .
Give information or assistance as necessary.
To arrange a conference requested by an outside party:
1.
2.
3.
4.
5.
6.
Acknowledge the request for a conference, and verify that conference BUSY light is
off. (BUSY light is on only when all conference circuits are busy.)
Press [CONF] .
Associated CONT light goes on. Display light goes off.
If CDRR is assigned and calls are to be charged to an account number, do Steps 4
and 5; if CDRR is not assigned, go to Step 6.
Press [START] .
Listen for dial tone.
Dial CDRR account
Listen for dial tone.
SPLIT light goes on. Caller is separated from the connection.
number access code and Account Charge Number.
If an outside party is the first added-on conferee, you do not have to activate CDRR
again. The added-on trunk will be automatically recorded. Do a, b, or c to connect a
trunk:
a. Dial AAR/ARS access code.
Listen for dial tone.
b. Press direct trunk group select button.
Listen for dial tone. ANS light goes on.
c. Press [START] , and dial Trunk Group access code.
Listen for dial tone. ANS light goes on. Other conferee is separated from the
connection.
4-48