AT&T System 85 - Manual (Page 67)

CHAPTER 4. OPERATING FEATURES
4 .
5 .
6 .
7 .
8 .
9 .
10.
If the call is to be placed on a private network and Automatic Alternate Routing
(AAR)/Automatic Route Selection (ARS) feature is active, do Step 5 to connect a
trunk; if AAR/ARS is not active, go to Step 6.
Press [START] , and dial AAR/ARS access code.
Listen for dial tone. SPLIT light goes on. Go to Step 9.
If you use direct trunk group selection to select trunks, do Step 7. If you do not use
direct trunk group selection, go to Step 8.
Press direct trunk group select button.
Listen for dial tone. ANS light goes on. Go to Step 9.
Press [START] , and dial Trunk Group access code.
Listen for dial tone. ANS light goes on. SPLIT light goes on. Other conferees are
separated from the connection.
Dial the outside number.
Listen for ringback tone until called party answers. If you used AAR/ARS to connect
a trunk, ANS light goes on.
Announce the conference to the called party, and do a or b.
a. To add the conferee, press [CONF] .
ANS and SPLIT lights go off.
b. If unable to add the conferee, press [CANCL] .
Called party is released. You have established a connection with the
conference. ‘Advise the conferees.
11. To release from the conference, press [RELEASE] . However,
sure one conferee is an extension number user and is
Otherwise outside parties will be disconnected.
before releasing, make
local to the attendant.
12. If you are recalled by the conference, the ATND light flashes. You hear an audible
ring. Press the loop button below the flashing ATND light.
ATND light goes on. Audible ring stops. Display shows CONF.
13. Give information or assistance as necessary.
4-45