AT&T System 85 - Manual (Page 48)

CHAPTER 4. OPERATING FEATURES
2 . Press [START] , and dial Cancel Code.
Listen for dial tone.
3. If you use direct trunk group selection to select trunks, do Step 4. If you do not use
direct trunk group selection, go to Step 5.
4. Press direct trunk group select button of trunk group for which
canceled.
Listen for tone:
Confirmation tone—control of trunk group is canceled. CONT light
trunk group goes off. Go to Step 6.
Intercept tone— incorrect dialing or control of trunk group is already
control is to be
for the specified
canceled. Go to
Step 6.
5 .
Dial Trunk Group access code of trunk group for which control
Listen for tone:
Confirmation tone—control of trunk group is canceled. CONT
trunk group goes off.
is to be canceled.
light for the specified
Intercept tone— incorrect dialing or control of trunk group is already canceled.
6. Press [RELEASE] .
PA light goes on. ATND light goes off.
Attendant Control of Trunk Group
(DCS) Environment
Access to trunk groups used at one
distant system by the attendant.
Access in a Distributed Communication System
system in a DCS environment may be controlled at a
Feature operation is the same as previously described except for the following:
◆ A direct trunk group select button must be assigned on your console and on the
console at the distant system for any trunk groups you are controlling at the distant
system.
◆ When busy or warning levels are exceeded for a trunk group with a direct trunk
group select button assigned, the BUSY or WARN lights on all consoles, in the DCS
with an appearance of that trunk group, go on.
4-26