AT&T System 85 - Manual (Page 64)

CHAPTER 4. OPERATING FEATURES
Code Calling Access
Allows you access to loudspeaker paging equipment by dialing an access code and a Called
Party Code. The called party hears the Electronic Chime Code.
To access and page:
1.
2.
3.
4.
5.
6.
7.
Press an idle loop button.
ATND light goes on. PA light goes off.
Press [START] .
Listen for dial tone.
Dial Code Calling access code.
Listen for tone:
Dial tone— ANS light goes on. Do Steps 4, 5, and 6.
Busy tone—code calling circuit is busy. Go to Step 7.
Dial the Called Party Code.
Listen for confirmation tone. Then listen for the Called Party
three times. Then listen for ringback tone (System 85 only).
If an answer is required, stay on the line until the called party is
Press [RELEASE] .
ANS and ATND lights go off. PA light goes on.
Code to be repeated
connected.
Press [RELEASE] .
ATND light goes off. PA light goes on.
To access and page for a caller who is on the line:
1. Ask the caller to wait for an answer.
2. If Call Detail Recording and Reporting (CDRR) is assigned and calls are to be
charged to an account number, do Steps 3 and 4; if CD-RR is not assigned, press
[START] , listen for dial tone, and go to Step 5.
3. Press [START] .
Listen for dial tone. SPLIT light goes on. Caller is separated from the connection.
4-42