AT&T System 85 - Manual (Page 80)

CHAPTER 4. OPERATING FEATURES
2.
3.
4.
5.
6.
7.
8.
9.
10.
If you use direct trunk group selection to select radio paging trunks, do Step 3. If you
do not use direct trunk group selection, go to Step 4.
Press direct trunk group select button.
Listen for dial
Press [START] ,
Listen for dial
Dial individual
tone. ANS light goes on.
and dial Radio Paging access code.
tone. ANS light goes on.
Page Number.
Listen for ringback tone until paging signal has been transmitted. If voice paging is
available, go to Step 6; if tone paging only is available, go to Step 10.
Announce paging message. If a caller is waiting to talk to the paged party, go to
Step 9. If a caller is not waiting, do Steps 7 and 8.
If an answer is expected, stay on the line until the called party is connected.
At the end of conversation, press [RELEASE] .
ANS and ATND lights go off. PA light goes on.
Press [HOLD] .
HOLD and PA lights go on. Display and ATND lights go off. Caller is connected to
the paged party.
Press [RELEASE] .
Display and ATND lights go off. PA light goes on.
Remote Access
Allows users on a public network to access the services of your system by dialing a single
security code (barrier code) or an individual authorization code. You may have to change the
barrier code (same code for all remote access users) from time to time for security reasons.
To change the barrier code:
1. Press an idle loop button.
PA light goes off. ATND light goes on.
4-58