AT&T System 85 - Manual (Page 43)

CHAPTER 4. OPERATING PROCEDURES
10. Dial the outside number.
Listen for ringback tone until called party answers. ANS light goes on at this point if
you used AAR/ARS to connect a trunk.
11. Ask the called party to wait to be connected.
To connect the second outgoing trunk:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
If the call is to be placed on a private network and AAR/ARS feature is active, do
Step 2 to connect a trunk; if AAR/ARS is not active, go to Step 3.
Press [START] , and dial AAR/ARS access code.
Listen for dial tone. SPLIT light goes
connection.
If you use direct trunk group selection to
direct trunk group selection, go to Step 5.
Press direct trunk group select button.
Listen for dial tone. ANS light goes on.
on. First called party is split from the
select trunks, do Step 4. If you do not use
SPLIT light goes on. First called party is
separated from the connection. Go to Step 6.
Press [START] , and dial Trunk Group access code.
Listen for dial tone. ANS light goes on. SPLIT light goes on. First called party is split
from the connection.
Dial the outside number.
Listen for ringback tone until called party answers.
Ask the second called party to wait to be connected.
Press [HOLD] .
HOLD and PA lights go on. ATND and SPLIT lights go off. Both outside parties are
connected.
Periodically press the loop button (on which the call is held) to check if both trunks
are still in use.
When both parties have disconnected, press [CANCL] , [RELEASE] .
Display and ATND lights go off. PA light goes on.
4-21