AT&T System 85 User Manual
Page 101
CHAPTER 4. OPERATING FEATURES
2.
3.
4.
Lift the handset.
Listen for dial tone.
Dial the code for the required mode.
Listen for confirmation
operation and flashes in
Hang up.
tone. The CONTROL light goes on in the CAS mode of
the CAAVT mode or in the backup mode.
Incoming Calls—Non-CAS
To answer an incoming call at the special services console:
You hear an audible ring. ATND light flashes. PA light goes off.
1.
Press
[ANSWER]
.
Audible ring stops. ATND light goes on.
2.
Answer the call, and provide the service requested by the caller.
The following types of service may be requested:
◆
Connection to an outgoing trunk when the attendant is controlling trunk groups.
◆
Busy verification of lines or trunks.
◆
Checking of trunks when Automatic Circuit Assurance (ACA) is activated in the
system.
◆
Setting up attendant-controlled conferences.
Changing Facilities Restriction Levels (FRL) to upgrade calling privileges so that a
◆
user can access a trunk group.
◆
Setting up serial calls—a call from a branch user is extended by a CAS attendant to
a user at another branch. The calling user is requesting the special services console
attendant at that branch to make a series of calls.
◆
Setting up trunk-to-voice terminal assignments so that call
preselected telephones/voice terminals can be put in operation.
Operating procedures for the services listed are included in this section
heading in the “Operation Of Features” section.
answering from
under the feature
4-79