American Dryer Corp. AD-15 Phase 7 - Manual (Page 24)

22 American Dryer Corp. 113243-1
PROCEDURE FOR
FUNCTIONAL CHECK OF
REPLACEMENT
COMPONENTS
Microprocessor Controller (Computer) Board
Phase 7 Coin Models
•
Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
•
Start the drying cycle by pressing any temperature
selection keys (HI, MED, or LO).
•
Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)
Phase 7 Non-Coin Models
•
Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
•
Start the drying cycle by pressing any of the preset
cycles in letters A-F.
•
Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)