American Dryer Corp. AD-15 Phase 7 - Manual (Page 20)

18 American Dryer Corp. 113243-1
Mechanical Drop/Rotary Coin Meter or Slide Coin Meter
•
Insert coin and turn knob (rotary type meter), or for
slide meter unit, push in coin chute.
•
Select Temperature.
•
Push the “Start” button.
•
To stop dryer, open the main door.
Non-Coin Models
The light emitting diode (L.E.D.) display reads “READY” (no
cycle in progress).
Press the letter on the keyboard (touch pad) corresponding
to the cycle desired (i.e., key “D”).
NOTE:
“0-40” WILL REQUIRE THE “START/ENTER”
Ãy
KEY TO BE PRESSED AFTER THE NUMBER
IS SELECTED IN ORDER TO ACCEPT THE
SELECTION AND START DRYING.
The dryer will then start. (I.E., blower, basket [tumbler], and
heat).
The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00
MIN REMAIN.
NOTE:
Press and hold the “UP ARROW” to view the
basket (tumbler) temperature at any time.
The dryer can be stopped at any time by
pressing the “STOP/CLEAR”
2
key, at this time
the dryer will go into a cycle pause. If the
“STOP/CLEAR”
2
key is pressed again at this
point, the cycle that was in progress will be
cancelled and returned to the “READY” state.
Press and hold the “DOWN ARROW” to view
the basket (tumbler) RPM.
When the programmed drying time has expired, the Phase 7
non-coin microprocessor controller (computer) will proceed
into the Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read COOL DOWN TEMP
___/___ MINUTES REMAINING. At the end of the heat cycle,
the dryer will shut off the heat and continue the fan and basket
(tumbler) until the Cool Down Time or temperature is reached.
IMPORTANT:
For more detailed information regarding the
microprocessor controller (computer) on your
dryer, refer to the microprocessor user’s manual
included with the dryer.
Dual timer dryers
•
Turn drying timer knob for a time of 20 minutes.
•
Select “High Temp.”
•
Push “Push to Start” switch.
•
To stop dryer, open the main door.
7,0,1* /(*(1'
TQDIÃUDH@
6qwˆ†‡€r‡ÃQ‚†v‡v‚ÃIˆ€ir
! " # $
Uv€rÃvÃTrp‚q† " % ( ! $
9X@GGÃTUPQÃUDH@
6qwˆ†‡€r‡ÃQ‚†v‡v‚ÃIˆ€ir
! " # $
Uv€rÃvÃTrp‚q† $ %" &% '( !
ÃWhyˆr†Ã†u‚Ãh rГГ †rp‚q
Spin and dwell (stop) times are adjustable at the
reversing timer.
REVERSING TIMER SPIN/DWELL ADJUSTMENTS
Timer models have an electronic reversing timer in the
electrical service box, which is located in the upper left rear
area of the dryer.
Both the Dwell (stop) Time and the basket (tumbler) Spin
Time are adjustable by mode selection switches located on
the electronic timer (as noted in the illustration below).
!
!
!