Canon XA10 - Manual (Page 65)

Exposure Adjustment
65
Using the Zebra Pattern
You can use the zebra pattern to identify areas that might be overexposed, so you can correct the
exposure appropriately. The camcorder offers two levels of zebra pattern: With 100% only areas that
will lose detail in the highlight areas will be identified, while 70% will identify also areas that are
dangerously close to losing detail.
1 From the exposure adjustment screen, touch [5] to select the zebra level.
2 Touch [70%] or [100%] and then touch [f].
3 Touch [a] or [b] and then touch [a].
• The zebra pattern will appear on the overexposed areas of the picture.
• Touch again to turn off the zebra pattern.
NOTES
• Using the zebra pattern will not affect your recordings.
Exposure Compensation
When you use a recording program other than [ y Manual Exposure], the camcorder will adjust the
exposure automatically. However, you can adjust and lock the exposure or use the Touch AE function
to automatically set the optimal exposure for the subject you select. This is convenient when the
brightness of the subject you want to shoot is noticeably brighter/darker than the general brightness of
the image.
POINTS TO CHECK
• Select a recording program other than [ M Fireworks] or [y Manual Exposure].
• Exposure adjustment is not available in infrared mode.
Operating modes:
COP
Y