Canon XA10 - Manual (Page 47)

Recording Movies and Photos
47
IMPORTANT
• Observe the following precautions while the ACCESS indicator is on or flashing. Failing to do so
may result in permanent data loss or damage to the memory.
- Do not open the double memory card slot cover.
- Do not disconnect the power source or turn off the camcorder.
- Do not change the camcorder’s operating mode.
• Be sure to save your recordings regularly ( 0 132), especially after making important recordings.
Canon shall not be liable for any loss or corruption of data.
• Photos recorded on an Eye-Fi card in memory card slot Y will be uploaded automatically after
setting the camcorder to playback mode, if you are within the range of a configured network.
Always verify that Eye-Fi cards have been approved in the country/region of use. See also Using an
Eye-Fi Card (
0 142).
NOTES
• The START/STOP button on the handle has a lock lever to prevent accidental operation. Set the
lock lever to R in cases such as when you do not want a recording inadvertently paused or do not
plan to use this START/STOP button. Return the lever to its previous position to enable use of the
START/STOP button again.
• About the power saving mode: If 6 [Power Saving Mode] [Auto Power Off] is set to
[A On], the camcorder will shut off automatically to save power when it is powered by a battery
pack and is left without any operation for 5 minutes. Press
x to turn on the camcorder.
• When recording in bright places, it may be difficult to use the LCD screen. In such cases, you can
turn on the LCD backlight ( 0 27) or adjust the brightness of the LCD screen with the 6
[LCD Brightness] setting. Alternatively, you can also use the viewfinder ( 0 25).
COP
Y