Converting only part of a scene or, Story 142, Uploading your videos wirelessly 142 – Canon XA10 User Manual
Page 142: Cop y
Uploading Movies to Video Sharing Web Sites
142
Converting Only Part of a Scene or Story
1 Play back the scene or story that you want to partially convert.
• Check that you have selected a scene recorded in the built-in memory or on memory card X.
2 Pause the playback where you want the converted SD movie to begin.
3 Press Z and continue the conversion to standard definition from step 5 in the previous
procedure (
0 139).
• The video from the playback pause until the end of the scene/story (or up to a maximum of
10 minutes, in case of longer scenes/stories) will be converted to standard definition.
Uploading your Videos Wirelessly
If you are using an Eye-Fi card, you can automatically upload the converted SD movies to your favorite
video sharing Web site. You will need to have installed the software supplied with your Eye-Fi card and
completed all the required configuration setup in advance. Refer to the instruction manual of the Eye-Fi
card.
Please read the IMPORTANT section before using an Eye-Fi card.
1 Insert your Eye-Fi card into memory card slot Y and make sure there is sufficient
available space on the memory card.
2 Convert the desired movies (
0 139).
• When the conversion is completed, touch [End Without Connecting].
• If you are within the range of a configured network, Web upload will start automatically.
• The status of the wireless communication is shown by the Eye-Fi icon as follows:
- g (grayed out) Communication not established
- g (white, flashing) Connecting; g (white, continuously on) Wireless upload on standby
- g (animated) Wireless upload in progress
- i [Eye-Fi Communication] is set to [B Off]
- h Wireless upload stopped by the camcorder (
0
- o Error reading from the Eye-Fi card (
0
IMPORTANT
Using an Eye-Fi Card
• This product is not guaranteed to support Eye-Fi card functions (including wireless transfer). In case
of an issue with an Eye-Fi card, please check with the card manufacturer. Also note that an approval
is required to use Eye-Fi cards in many countries or regions. Without approval, use of the card is not
permitted. If it is unclear whether the card has been approved for use in the area, please check with
the card manufacturer.
• Do not use Eye-Fi cards on airplanes and in other places where wireless communication is
forbidden. Remove the Eye-Fi card from the camcorder beforehand.
COP
Y