Brother MFC-9130CW - Manual (Page 36)

Configuring your machine for a wireless network (For DCP-9020CDW, MFC-9130CW, MFC-9330CDW and MFC-9340CDW)
30
3
a
Press .
b
Press Network .
c
Press WLAN .
d
Swipe up or down, or press a or b to display WPS w/PIN Code .
Press WPS w/PIN Code .
e
When Enable WLAN? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press
No .
f
The Touchscreen will show an 8 digit PIN and the machine starts searching for an access point.
g
Using a computer that is on the network, type “vaccess point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
1
.) Go to
the WPS setting page and input the PIN which the Touchscreen shows in f to the Registrar. Follow the
on-screen instructions.
1 The Registrar is normally the WLAN access point / router.
NOTE
The setting page is different, depending on the brand of access point / router. See the instruction manual
supplied with your access point / router.