Brother DCP-395CN - Manual (Page 93)

Wireless Configuration for Macintosh using the Brother installer application (For DCP-373CW, DCP-375CW, DCP-377CW,
DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
84
5
l
If the LCD shows Connected, the machine has successfully connected to your router or access point.
You can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the SecureEasySetup™ mode, the
Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only one access point/router
has the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or the AOSS™ mode enabled
and try starting from i again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or AOSS™ mode
enabled. Move the machine closer to your access point/router and try starting from i again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from i again. If the same message is indicated again, reset the machine back
to the default factory settings and try again. (For resetting, see Restoring the network settings to factory
default on page 114.)
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access point,
and downloading settings from the access
point.
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting to the access point. —
Connected Connection succeeded. —
Connection Error Session overlap has been detected.
Check that only one router or access
point has the SecureEasySetup™
mode, the Wi-Fi Protected Setup™
mode or AOSS™ mode enabled and try
starting from step i again.
No Access Point The access point detection failed.
Move the machine closer to your
access point/router and try starting from
step i again.
Connection Fail
The machine was not able to connect with
the access point.
„ Try starting from step i again.
„ If the same message reappears,
reset the machine back to the
factory settings and try again.