Brother DCP-395CN - Manual (Page 105)

Control panel setup
96
6
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose BOOT Method.
Press OK.
f
(For DCP-365CN, DCP-373CW, DCP-375CW, DCP-377CW, MFC-253CW, MFC-255CW, MFC-257CW
and MFC-295CN)
Press a or b to choose Auto
1
, Static
2
, RARP
3
, BOOTP
4
or DHCP
5
.
Press OK.
(For DCP-395CN, DCP-593CW, DCP-595CW, DCP-597CW and MFC-495CW)
Press d or c to choose Auto
1
, Static
2
, RARP
3
, BOOTP
4
or DHCP
5
.
Press OK.
g
Press Stop/Exit.
For Touchscreen models
6
a Press MENU.
b Press Network.
c
(For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e
Press BOOT Method.
f
Press Auto
1
, Static
2
, RARP
3
, BOOTP
4
or DHCP
5
.
g
Press Stop/Exit.
1 Auto mode
In this mode the machine will scan the network for a DHCP server. If it can find one, and if the DHCP server is configured to allocate an IP address
to the machine, then the IP address supplied by the DHCP server will be used. If no DHCP server is available, then the machine will scan for a
BOOTP server. If a BOOTP server is available, and it is configured correctly, the machine will take its IP address from the BOOTP server. If a
BOOTP server is not available, the machine will scan for a RARP server. If a RARP server also does not answer, the IP Address is set using the
APIPA protocol, see Using APIPA to configure the IP address on page 139. After the machine is initially powered ON, it may take a few minutes
for the machine to scan the network for a server.
2 Static mode
In this mode the machine’s IP address must be manually assigned. Once entered the IP address is locked to the assigned address.
3 RARP mode
The Brother print server IP address can be configured using the Reverse ARP (RARP) service on your host computer. For more information on
RARP, see Using RARP to configure the IP address on page 139.
4 BOOTP mode
BOOTP is an alternative to RARP that has the advantage of allowing configuration of the subnet mask and gateway. For more information on
BOOTP, see Using BOOTP to configure the IP address on page 138.
5 DHCP mode (DHCP)
Dynamic Host Configuration Protocol (DHCP) is one of several automated mechanisms for IP address allocation. If you have a DHCP server in
your network (typically a UNIX
® , Windows ® 2000/XP, Windows Vista ® network) the print server will automatically obtain its IP address from a
DHCP server and register its name with any RFC 1001 and 1002 compliant dynamic name services.