Brother MW-260 - Manual (Page 51)

29
ESC iXr2 Specify print start received character count
[ASCII] ESC i X r 2 n1 n2 n3 n4
[Decimal] 27 105 88 114 50 nd1 nd2 nd3 nd4
[Hexadecimal] 1B 69 58 72 32 nh1 nh2 nh3 nh4
[Parameters] nh1:02h (Fixed)
nh2:00h (Fixed)
00h≤nh3≤FFh
00h≤nh4≤03h
[Description]
· Specifies the number of characters to be received to start printing.
nh3+(nh4*256): Print start received character count (bytes) (1 to 999)
· The default print start received character count is 10.
· This command is a static command.
[Example]
· To change the print start received character count to 100 characters: Since nh3=64h and
nh4=00h, the command will be as follows.
ESC i X r 2 02h 00h 64h 00h
(1Bh 69h 58h 72h 32h 02h 00h 64h 00h)